NEWS

Home page

Electric furnace tempering

Release time ：

2022-09-24

The sliding type and mechanical flexible interface mode are adopted, and the construction is simple. And it can operate safely for a long time. The compressive strength of ductile iron pipe is higher than that of steel pipe.

Ductile cast iron pipe material plasticity Ductile cast iron pipe elongation indicates the ability of the material not to break when large plastic deformation occurs, and impact resistance indicates the ability of the material not to be damaged when subjected to sudden load. The product quality conforms to the national standard of Centrifugally Cast Ductile Iron Pipe.

Ductile iron pipes are really close to the properties of steel

China first introduced the centrifugal ductile iron pipe production line in 1986. In 1991, the national standards GB13295-91 Centrifugally Cast Ductile Iron Pipe and GB13294-91 Ductile Iron Pipe Fittings were issued. After 1993, the casting pipe technology became increasingly mature. The products used in water supply and gas engineering in China have been exported, with an annual output of about 700000 tons.

Water delivery: when the diameter of ductile iron pipe is ≤ 300mm, the maximum allowable working pressure is 3 - 4Mpa; When the pipe diameter is 350-1000mm, it is 2-3Mpa; When the pipe diameter is greater than 1000mm, it is 1.6-2Mpa.

Ductile iron pipe has machinability and corrosion resistance.

Prestressed concrete pipes have been put into production in China since 1968, and the pipe making technology of ductile iron pipes has also been gradually improved with the development of industrial technology. Due to the limitation of the tightness of the interface, they are generally used for working pressure below 0.6Mpa, and their diameters are ideal within the range of 1000-1400mm. Ductile iron pipe, mainly used in water supply and gas pipeline engineering, is a kind of pipe with great development prospects.

N1 type interface seal adopts the principle of external elastic pressure seal. The working face of the socket is a single inclined plane, and the section of the interface gap is wedge-shaped, which is consistent with the section shape of the seal ring. With the elasticity of the rubber ring and the pre pressure during installation, the rubber ring is compressed and deformed, and the working face is compressed to obtain the sealing effect. In order to prevent the corrosion of the gas on the sealing rubber ring, in addition to the strict requirements for the rubber material, necessary technical measures are taken in the interface design.

mechanical